Most small aircraft use a direct-cranking electric starter system. This system consists of a source of electricity, wiring, switches, and solenoids to operate the starter and a starter motor. Most aircraft have starters that automatically engage and disengage when operated, but some older aircraft have starters that are mechanically engaged by a lever actuated by the pilot.
The starter engages the aircraft flywheel, rotating the engine at a speed that allows the engine to start and maintain operation.
Tag: Flying instrument, instrument flight, aviation, piloting, instrument rating, instrument flying training, instrument flight rating, instrument rating requirement, instrument rating regulation, aircraft, aeronautic, airplane, and aeronautical knowledge.
Electrical power for an on-board battery usually supplies starting, but can also be supplied by external power through an external power receptacle. When the battery switch is turned on, electricity is supplied to the main power bus through the battery solenoid. Both the starter and the starter switch draw current from the main bus, but the starter will not operate until the starter switch being turned to the "start" position energizes the starting solenoid. When the starter switch is released from the "start" position, the solenoid removes power from the starter motor. The starter motor is protected from being driven by the engine through a clutch in the starter drive that allows the engine to run faster than the starter motor.
When starting an engine, the rules of safety and courtesy should be strictly observed. One of the most important is to make sure there is no one near the propeller. In addition, the wheels should be choked and the brakes set, to avoid hazards caused by unintentional movement. To avoid damage to the propeller and property, the airplane should be in an area where the propeller will not stir up gravel or dust.
No comments:
Post a Comment